5 May 2013

On to a new board


Hmmm so after several months of work I am still struggling to get all the gremlins out of the over-complex control panel. So I have turned my mind back to woodwork. Everytime you do woodwork you remind yourself that almost all wood you can buy is expensive and warped...

More expensive this time as I had a couple of big sheets of ply for the next couple of boards and so needed to pay a delivery charge from Inverness.

I have used my standard wall mounted L-girder technique - though the pictures below show with only one girder fitted.

I have used 100mm sections to hold baseboard surface rather than previous 90mm as this gives just a little more room for getting edge connectors on and off the Tortoise point motors.




some placeholder words for the tool tipsome placeholder words for the tool tipsome placeholder words for the tool tip
click here to return to the blog